Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SIDE BROOM HEIGHT CHECK AND ADJUSTMENT
NOTE
Brooms with harder or softer bristles are available.
This procedure is applicable to all types of brooms.
NOTE
This procedure is applicable to both the right side
broom and left side broom (optional).
Check
1.
Drive the machine on a level floor.
2.
Turn the ignition key (2) to "I".
3.
Lower the side broom with the lever (12).
4.
The proper side broom height is reached when the bristles
touch the floor along a circle arc as shown (A, Fig. 5).
If the print (A) is not within specifications, adjust the broom
height.
Adjustment
5.
Turn the ignition key (2) to "0".
6.
Loosen the nut (C, Fig. 6) under the cover (B) and turn the
screw (D) clockwise or counter-clockwise to increase or
decrease the side broom height. Then lock the screw with
the nut.
7.
Perform step 4 again to check that the side broom is at the
correct distance from the ground.
8.
When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.
CAUTION!
If the side broom print is excessive, the machine
regular operation is affected and the moving
parts or electrical components can overheat, thus
reducing machine life.
SIDE BROOM DISASSEMBLY/ASSEMBLY
CAUTION!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
NOTE
This procedure is applicable to both the right side
broom and left side broom (optional).
1.
Drive the machine on a level floor.
2.
Turn the ignition key (2) to "0".
3.
Loosen the knob (A, Fig. 7) inside the side broom, then
remove the broom (B) by disengaging it from the three pins
(C).
4.
Install the new broom on the machine engaging it on the
pins (C), then tighten the knob (A).
5.
Adjust the height of the new broom according to the
procedure shown in the previous paragraph.
INSTRUCTIONS FOR USE
Figure 5
B
Figure 6
B
C
A
Figure 7
1465374000 - SW900
ENGLISH
A
P100820
C
D
P100821
C
C
P100822
17
Publicidad
Capítulos
Tabla de contenido
