Squeegee Cleaning; Squeegee Blade Check And Replacement - Advance Micromatic M17E Instrucciones De Uso

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
CAUTION!
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.
1. Drive the machine on a level fl oor.
2. Make sure that the power supply cable (21) is disconnected from the electrical mains.
3. Lower the squeegee with the lever (19).
4. Disconnect the vacuum hose (22) from the squeegee.
5. Loosen the handwheels (12) and remove the squeegee (11).
6. Wash and clean the squeegee; in particular, clean the compartments (A, Fig. 6) and the vacuum hole (B) from dirt and debris.
7. Check the front blade (C) and the rear blade (D) for integrity, cuts and tears; if necessary replace them (see the procedure in
the following paragraph).
8. Assemble in the reverse order of disassembly.

SQUEEGEE BLADE CHECK AND REPLACEMENT

1. Clean the squeegee as shown in the previous paragraph.
2. Check that the edges of the front blade (E, Fig. 6) and of the rear blade (I) lay down on the same level, along all their length;
otherwise adjust their height as shown below:
• Remove the fi xing springs (F) and adjust the front blade (C) and the rear blade (D).
• Install the mounting springs on the front and rear blades.
3. Check the front blade (C) and rear blade (D) for integrity, cuts and tears; otherwise replace them according to the following
procedure. Also check the front corner (H) of the rear blade for wear; if it is worn, overturn the blade to replace the worn corner
with the other one (I), if it is integral. If the other corner is worn too, replace the blade according to the following procedure:
• Remove the fi xing springs (F) and replace (or overturn) the rear blade (D).
• Install the mounting springs on the front and rear blades.
4. Install the squeegee (11) and screw down the handwheels (12).
5. Connect the vacuum hose (22) to the squeegee (11).
5 9
12
1
7
Micromatic™ M17E
INSTRUCTIONS FOR USE
2
6
Figure 6
909 5855 000(3)2008-11
ENGLISH
4
1
6
17
3
S310240