Publicidad
Water is not supplied.
The Water Level sensor is not
working properly.
Water is not draining.
The lid is open.
Spinning does not work.
The unit is out of balance in
spin operation.
Load sensing failed.
Water Leveling sensing failed.
Notice:
1.LED Display:
1)When error happening, Extra Rinse LED will flash and Process LED indicates error code.
2
)
-off,
-flash,
-on
2.When error happening, the buzzer will beep 5 seconds and repeat once per 15minutes.
After 24 hour, machine will power off automatically.
3.When other error happening, please try again first, call up service line if there are still
troubles.
•Make sure the water taps are open.
•Make sure the water hoses are not clogged.
•Make sure he water taps are not frozen.
•Make sure the washing machine is operating
with sufficient water pressure.
•Make sure that the cold water tap and the
hot water tap are properly connected.
•Clean the mesh filter as it may be clogged.
•Check WaterLevel Sensor wire harness.
•If the information code remains, Call service
center.
• Make sure the drain hose is not frozen or
clogged.
• Make sure the drain hose is positioned
correctly, depending on the connection
type.
• Clean the debris flter as it may be clogged.
• Make sure the drain hose is straightened all
the way to the drain system.
• If the information code remains, Call service
center.
•Close the lid. See Installation instructions to,
"Level your washer".
•The door lock or PCB may have failed, try
steps again.
•If the information code remains, Call service
center.
• Make sure laundry is spread out evenly.
•Make sure the washing machine is on a flat,
stable surface.
•Redistribute the load. If only one item of
clothing needs washing, such as a bathrobe
or pair of jeans, the final spin result might
be unsatisfactory.
•Adjust the washer level refer to installation
instructions.
•If situation continues, call service center
•Call service center.
•Call service center.
Publicidad
