K-Series attract
IMPORTANT!
– Make sure that the snap hooks are covered with
slip resistant material to avoid laterally slipping
on the axle.
IMPORTANT!
– Check the plungers are fully engaged on both
sides and located in the same position of the
cut-out section of the rail.
– Make sure that the angle between the rails and
the straps lies between 40° and 45°.
Fit posture belt
WARNING!
The posture belt must be used in addition to but
never as a substitute for an approved passenger
restraint system (3-point belt).
1.
Adjust posture belt to fit the wheelchair occupant, see section
4.1 Pelvic belt, page 16.
32
Fastening the 3-point passenger restraint system
IMPORTANT!
The illustration above may differ depending on the
restraint system supplier.
1583571-A