Infiniton FGC-182EN Manual De Usuario página 32

11
④
5. Unscrew the two special flange self-
tapping screws which are used for
fixing the middle hinge part, then
remove the middle hinge part that hold
the lower door in place.
NOTE: When removing the door, watch
for washer(s) between the center hinge
and the upper of the lower door that
may stick to the door. Don't los it.
6. Place the lower door on a smooth
surface with its panel upwards.
Loose screw ③
and part ② , then Install door stopper-
left ④( provided in the plastic bag) and
left part ② and screw
and tighten them securely.Keep part ①
with the appliance for future reference.
①Door stopper
②Stop block
③Self-tapping screw
①
②
③
④ -
Door stopper left
e
①
and take down part
③ to the left side
①Door stopper
②Stop block
③Self-tapping screw
①
②
③
④
7. Change screw and screw hole covers
on midde cover plate from left to right (as
shown in figure below).
screw screw hole covers
8. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts ,
then remove the lower hinge part
unscrewing the special flange self-
③
tapping screws .
①
②
③
①Adjustable bottom feet part
② ( )
Lower hinge part right
③Self-tapping screw
①
9.Remove part from the lower
hinge part(right), loose out the lower
hinge pin, change it to the reverse
hole site, and then tighten into
position, then install part
lower hinge pin.
10. Change screw hole covers on lower
cover plate from left to right (as shown
in figure below).
screw hole cover
④Door stopper left -
screw
screw hole covers
①
②
by
①
on the
①
screw hole cover