Publicidad
Idiomas disponibles
Idiomas disponibles
17
Cleaning and care
For
hygienic
reasons
(including exterior and interior accessories)
should be cleaned regularly at least every
two months.
The
appliance
Caution!
connected
to
the
Danger of electrical shock! Before cleaning
switch the appliance off and remove the plug
from the mains socket.
Exterior cleaning
To
maintain
good
appliance, you should clean it regularly.
-Wipe the control panel with a clean, soft cloth.
-Spray water onto the cleaning cloth instead
of spraying directly on the surface of the
appliance.
This
helps
distribution of moisture to the surface.
-Clean
the
doors,
surfaces with a mild detergent and then
wiped dry with a soft cloth.
Caution!
-Don't use sharp objects as they are likely to
scratch the surface.
-Don't use thinner, car detergent, clorox,
ethereal oil, abrasive cleansers or organic
solvent such as Benzene for cleaning. They
may damage the surface of the appliance
and may cause fire.
Interior cleaning
You
should
clean
regularly. It will be easier to clean when food
stocks are low. Wipe the inside of the fridge
freezer with a weak solution of bicarbonate
of soda, and then rinse with warm water
using a wrung-out sponge or cloth. Wipe
completely dry before replacing the shelves
and baskets.
Thoroughly dry all surfaces and removable
parts.
Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long. If the frost is too thick,
choose a time when the supply of food
stocks are low and proceed as follows:
the
appliance
must
not
be
mains
during
cleaning.
appearance
of
your
ensure
an
even
handles
and
cabinet
the
appliance
interior
1.Remove existing food and accessories
baskets, unplug the appliance from the
mains power and leave the doors open.
Ventilate the room thoroughly to accelerate
the thawing process.
2. When defrosting is completed, clean your
freezer as described above.
Caution! Don't use sharp objects to remove
frost from the freezer compartment. Only
after the interior is completely dry should the
appliance be switched back on and plugged
back into the mains socket.
Gasket cleaning
Take care to keep gaskets clean. Sticky
food and drinks can cause gaskets to stick to
the cabinet and tear when you open the
door. Wash gaskets with a mild detergent and
warm water. Rinse and dry it thoroughly after
cleaning.
Caution! Only after the gaskets are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning:
The LED light should be replaced by a
competent person. If the LED light is
damaged, contact the customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing
the connector latch.
4. Replace LED light and snap it
correctly in place.
Publicidad
