Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGE THE DRYER VENT LOCATION
Your new dryer is shipped to vent to the rear. It can also be configured to
vent to he bottom or left side (as seen from the front).
An Adapter kits which are standard components can be purchased from
any retailer. This kit contains the necessary duct components to change
the dryer vent location.
Tools and materials you will need
Phillips screwdriver
1. Remove the two rear exhaust retaining screws, then pull out the exhaust
duct.
Option 1: Side venting
P
ress
the tabs on the knockout and carefully remove the knockout f or
2.
the desired vent opening.
Attach the adapter duct onto the blower housing of the dryer as shown.
30
Rigid or UL
aluminum tape
flexible metal
'' (
.
4
10
Rear
Exhaust Duct
Adapter
Duct
Knockout
-
listed
'' (
Elbow 4
)
2 cm
duct
Retaining
Screw
.
)
10
2 cm
Gloves
Publicidad
