S&P CAD-REG Manual página 29

Time programming must be done day after day following the following sequence:
1
MOD MOD
I
Example of time programming:
Monday confi guration with two operating periods, morning from 8:00 am to 1:00 pm and afternoon from 2:30 pm to 6:30
pm.
5.2. CONFIGURATION OF THE TEMPERATURE PROBES AND CO
The confi guration of the temperature probes and CO
menu.
5.2.1. Confi guration of temperature probes
The controller CAD-REG control is supplied with two temperature probes that, once wired in the ducts or intakes
of outdoor air and extract air, allow to control the operation of the by-pass in free-cooling mode. These probes
are especially useful when the CAD-REG control is combined with recovery units from the CADB / T-HE ECOWATT
range as these units are not equipped with pre-wired temperature probes.
In the case of heat recovery units from the CAD-COMPACT ECOWATT range, these units already include tempera-
ture probes mounted inside them which are wired to the electrical cabinet.
5.2.2. Confi guration of the CO
The CAD-REG control allows working in automatic mode, adjusting the speed of the fans depending on the indoor
ambient CO level. By default, the CO
2
CO sensor (0-10V 0-2000ppm) or an AIRSENS CO2 sensor (0-10V 450-1200ppm).
2
+
Minutos Minutos
Minutes Minutes
-
Minutos Minutos
Minutes Minutes
1
O MOD
MOD
Cambiar de día
Change the day
Aceptar y salir
Accept and leave
sensor is done through Parameter 9 of the advanced parameters
2
sensor
2
function is disabled, when enabling it it is possible to defi ne a conventional
2
+ +
Minutos
Minutes
- -
Minutos
Minutes
2 2
MOD O
I
FUNCTIONALITY
2
+
Minutos
Minutes
EN
-
Minutos
Minutes
29