Metabo HPT RP 18DA Manual página 10

English
2. Battery Charger
Model
Input power source
Charging time
(At a temperature of 68°F (20°C))
Charging voltage
Charging current
Weight
NOTE
The charging time may vary according to temperature and power source voltage.
ASSEMBLY AND OPERATION
APPLICATIONS
○ Vacuuming of dust, solid materials (broken
glass, nails etc.), with the exception of material
that is hotter than 60 °C
○ Vacuuming of liquids
UNPACKING
○ Carefully unpack the device.
○ Take out the accessories in the tank before
work.
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○ How to install the battery.
Pull the knob for battery cover, and open the
battery cover.
Always insert it all the way until it locks in place
with a little click.
Knob for
battery cover
Battery cover
10
Open
Insert
Fig. 5
UC18YFSL
Single phase: AC 120 V 60 Hz
BSL1840M : Approx. 60 min
DC 14.4–18 V
DC 3.5 A
1.1 lbs. (0.5 kg)
○ How to remove the battery.
Open the battery cover, and while pressing the
2 latches (one on each side), slide it and pull it
out.
Battery
Latch
NOTE
Ensure that the battery cover is securely closed
after removing or installing the battery.
If any water or dust enters the body of the tool
or the terminals of the battery, a failure may
occur.
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
Pull out
Press
Fig. 6