Publicidad
Idiomas disponibles
Idiomas disponibles
English
MAINTENANCE AND INSPECTION
WARNING
○
For inspection and maintenance, be sure
to turn off the power switch and remove
the battery.
○
Do not work with wet hands. May cause
electric shock or injuries.
1.
General instructions
Clean the device (see "CLEANING" on
page 15).
For maintenance by the user, the vacuum cleaner
must be taken apart, cleaned and maintained, to the
extent possible, without endangering maintenance
staff or other people.
Preventive measures
Appropriate preventive measures include: cleaning
the device before disassembly; providing local
fi ltered forced ventilation where the vacuum cleaner
is disassembled; cleaning of the maintenance area
and providing suitable personal protective clothing
and equipment.
When carrying out maintenance or repairs, it is
essential to dispose of any contaminated objects
that cannot be adequately cleaned. These objects
must be disposed of using impermeable bags and
in accordance with the applicable regulations for
removing such waste.
2.
Replacing the fi lter
(1)
Clean the fi lter again before replacement
("2. PressClean" on page 13)
(2)
Set the switch to position "0"
Remove battery.
(3) Open the clamps. Remove the upper part of
the device from the tank.
(4)
Unscrew the screws on the bottom of the upper
part (Fig. 2 on page 8) so that the fi lter and fi lter
holder can be removed.
(5) Seal the removed fi lter immediately in a dust-
tight plastic bag and dispose of it in accordance
with regulations.
(6) Insert a new fi lter into the fi lter holder and use
the screw to attach it in the vacuum once again.
Ensure proper and secure position.
16
3.
Inspection of terminals (device and battery)
Check to make sure that swarf and dust have
not collected on the terminals.
On occasion check prior, during and after
operation.
CAUTION
Remove any swarf or dust which may have
collected on the terminals.
Failure to do so may result in malfunction.
4.
Storage
Storing in a place below 104°F (40°C) and out
of the reach of children.
NOTE
Storing lithium-ion batteries.
Make sure the lithium-ion batteries have been
fully charged before storing them.
Prolonged storage (3 months or more) of
batteries with a low charge may result in
performance
reducing battery usage time or rendering the
batteries incapable of holding a charge.
However, signifi cantly reduced battery usage
time may be recovered by repeatedly charging
and using the batteries two to fi ve times.
If the battery usage time is extremely short
despite repeated charging and use, consider
the batteries dead and purchase new batteries.
5.
Service and repairs
All quality devices will eventually require
servicing or replacement of parts because
of wear from normal use. To assure that only
authorized replacement parts will be used,
all service and repairs must be performed
by a metabo HPT AUTHORIZED SERVICE
CENTER, ONLY.
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when
used with batteries other than these designated
by us, or when the battery is disassembled and
modifi ed (such as disassembly and replacement
of cells or other internal parts).
deterioration,
signifi cantly
Publicidad
