Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
●
To avoid injury from an accidental start, turn the switch OFF and remove the plug from the
power source or remove the battery from the main body before making any adjustments.
●
All electrical or mechanical repairs should be done only by qualifi ed service technicians.
Contact metabo HPT Authorized Service Center.
Reduction in suction power:
See the instructions in the "CLEANING" on page 15.
•
Is the fi lter dirty? - clean.
•
Dust bag full? - replace.
•
Tank full? - empty.
•
Nozzle, tubes or hose blocked?- clean.
•
Is the battery weak? - Charge/replace battery.
Device will not start:
•
Is the battery empty? - Charge/replace battery.
•
Water level detection active - empty tank, set
switch to "0" and restart the vacuum at level "I"
or "II".
Particles are discharged at the outlet:
•
Is the fi lter defective? - Check the fi lter and
replace if required ("2. Replacing the fi lter" on
page 16).
WARNING
The device has shut down by itself:
Causes and remedies:
•
Battery almost fl at: (the electronics prevent
the battery form discharging totally and avoid
damage). If the capacity indicator fl ashes
after pressing the battery button to display the
battery capacity, then the battery is almost
empty and must be recharged.
•
Battery is not inserted properly: Check and
correct.
•
Long continuous overloading of the device will
activate the temperature cut-out.
Leave the device or battery to cool.
•
Water level detection active - empty tank, set
switch to "0" and restart the vacuum at level "I"
or "II".
English
17
Publicidad
