Metabo HPT RP 18DA Manual página 11

WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
<UC18YFSL>
1. Connect the charger's power cord to a
receptacle.
When the power cord is connected, the pilot
lamp will blink in red. (See Table 2)
WARNING
Do not use the electrical cord if damaged.
Have it repaired immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery
charger.
Battery
Pilot lamp
3. Charging
When inserting a battery in the charger, the
pilot lamp will light up continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red. (See Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as
shown in Table 2, according to the condition of
the battery charger or the battery.
Guide rail
Fig. 7
Table 2: Indications of the pilot lamp
ON/OFF at 0.5 sec.
intervals
Lights continuously
Lights for 1 sec. at
intervals of 0.5 sec.
ON/OFF at 0.1 sec.
intervals
NOTE
*1 If the red lamp continues to blink even after the
charger has been attached, check to confi rm
that the battery has been fully inserted.
*2 Battery overheated. Unable to charge.
Although charging will start once the battery
has cooled down even when left in situ, the
best practice is to remove the battery and allow
it to cool down in a shaded, well-ventilated
location before charging.
*3 Malfunction in the battery or the charger
– Fully insert the battery.
– Check to confi rm that no foreign matter is
stuck to the battery mount or terminals.
If there are no foreign objects, it is
probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.
○ If the pilot lamp does not blink in red even
though the charger cord is connected to the
power, it indicates that the protection circuit of
the charger may be activated.
Remove the cord or plug from the power and
then connect it again after 5 minutes or so. If
this does not cause the pilot lamp to blink in
red, please take the charger to the metabo HPT
Authorized Service Center.
○ When the battery charger has been continuosly
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
English
Before charging *
1
or
Charging complete
While charging
Overheat standby *
2
Charging impossible *
3
11