Descargar Imprimir esta página

Metabo HPT RP 18DA Manual página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

Table 5
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power is
nearly empty. Recharge the battery
soonest possible.
Blinks ;
Output suspended due to high
temperature.
Remove the battery from the tool and
allow it to fully cool down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be
the battery so please contact your
dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
CAUTION
Do not give a strong shock to the switch
panel or break it. It may lead to a trouble.
CLEANING
1.
General Cleaning Instructions
WARNING
Turn off the power switch and remove the
battery before cleaning the device.
Clean the tank and accessories with water. Wipe the
upper part with a damp cloth.
CAUTION
This device contains dust that is harmful
to health. Discharge and maintenance
operations (including disposal of the dust
collection tanks) must only be carried
out by qualifi ed specialists wearing
appropriate
protective
equipment.
Emptying the Tank
For dust class only permitted for dusts with
occupational exposure limits > 1mg/m
(1)
Set the switch to position "0"
(2)
Remove the battery
(3) Open the clamps. Remove the upper part of
the device from the tank.
(4)
Tip out the tank.
Disposing of the Dust Bag
(1)
Set the switch to position "0"
(2)
Remove the battery.
(3) Open the clamps. Remove the upper part of
the device from the tank.
(4)
Carefully remove the dust bag.
(5) Be careful with dust during disposal!
(6) Dispose of the vacuumed material in
accordance with legal regulations.
Clean the fi lter via PressClean
Clean the fi lter according to "2. PressClean" on
page 13.
Clean the fi lter manually
Remove the fi lter according to "2. Replacing
the fi lter" on page 16.
Occasionally tap the fi lter to remove any dust
that has gathered on it. If the fi lter is very dirty,
you can clean it with water and a soft brush.
Allow to fi lter to dry properly afterwards.
English
clothing
and
.
3
15

Publicidad

loading