Publicidad
Idiomas disponibles
Idiomas disponibles
Outside
Clean the outside of the refrigerator with
a damp cloth dipped in warm water and
mild soap.
Once every 6 months, clean the back of
the refrigerator with a vacuum cleaner or
a duster. The dust that accumulates
there interferes with proper functioning
of the condenser, and therefore of the
refrigerator, leading to higher energy
consumption. Disconnect the
refrigerator before cleaning and do not
touch the condenser or the compressor,
as they may be hot.
The drainage tray should be cleaned at
least once a year.
Water will enter the refrigerator if the
drainpipe becomes blocked; if this
happens, disassemble the light
protector and wash out the drain pipe.
Door seals
The rubber door seals should be
carefully cleaned with a damp cloth.
Rinse and dry them carefully to avoid
damage.
Substituting the light
Should the light fail, switch off at the
socket outlet and pull out the mains
plug.
Then ensure the bulb is screwed
securely in the bulb holder.
Replace the plug and switch on.
If the light still fails, obtain a
replacement E14 screw-cap type 15
Watt (Max) bulb from your local
electrical sore and then fit it.
Carefully dispose of the burnt-out light
bulb immediately.
37
Cleaning the water tray
The water tray is located in the rear part
of the Refrigerator. Its function is to
collect the water that appears because
of defrosting and allow it to evaporate.
Normally, it does not require special
care; however, in the event of overflow
or unpleasant odors, it should be
checked and cleaned. First, unplug the
refrigerator. Lift the tray slightly and lean
it a little, carefully removing the water.
(Caution: make sure that the drainage
tube is not too hot). After the tray is
clean, replace it in its original position.
Make sure that the tube is placed over
the tray before reinserting it. The tray
should be cleaned at least once a year.
Notes
After cleaning the refrigerator, check the
following:
1. Check to be sure the cord is not
damaged.
2. Check to see if the plug is properly
connected to the outlet.
3. Check to see if the grounding cable is
installed.
4. Check to see if the drain is clogged.
38
Publicidad
