Publicidad
Idiomas disponibles
Idiomas disponibles
Your refrigerator
was packed carefully for shipment.
Remove and discard shelf packaging
and tape. Do not
remove the serial plate.
Location
• Do not install refrigerator
near oven, radiator or
other heat source. If not possible, shield refrigerator
with cabinet material.
• Do not install where temperature
falls below 55 ° F
(13° C) or rises above 110° F (43 ° C). Malfunction
may occur at this temperature.
Measuring
the Opening
When installing your refrigerator,
measure carefully.
Allow '/;' space at top and 'f_"space behind the
machine compartment
cover (located in the rea0 for
proper air circulation.
Subflooring
or floor coverings
(i.e. carpet, tile, wood
floors, rugs) may make your opening smaller than
anticipated.
Some clearance
may be gained by using the leveling
procedure
under Leveling.
Important:
If refrigerator
is to be installed
into a
recess where the top of the refrigerator
is completely
covered, use distance from floor to top of hinge cap to
verify proper clearance.
Transporting Your Refrigerator
• NEVER transport
refrigerator
on its side. If an
upright
position is not possible, lay refrigerator
on its
back. Allow refrigerator
to sit upright for
approximately
30 minutes before plugging
it in to
assure oil returns to the compressor.
Plugging the
refrigerator
in immediately
may cause damage to
internal
parts.
• Use an appliance
dolly when moving refrigerator.
ALWAYS truck refrigerator
from its side or
back-NEVER
from its front.
• Protect outside finish of refrigerator
during transport
by wrapping
cabinet in blankets or inserting
padding
between the refrigerator
and dolly.
• Secure refrigerator
to dolly firmly with straps or
bungee cords. Thread straps through
handles when
possible. Do not over-tighten.
Over-tightening
restraints
may dent or damage outside finish.
Leveling
To protect
property and refrigerator
from damage,
observe the following:
• Protect vinyl or other flooring
with cardboard,
rugs,
or other protective
material.
• Do not use power tools when performing
leveling
procedure.
To enhance the appearance
and maintain performance
the refrigerator
should be level.
Note
• Complete any required door reversal, panel
installation
and/or a water supply connection,
before leveling.
Materials
Needed
• 3/8" hex head driver
• Carpenter's
level
1. Remove toe grille.
• Grasp firmly and
pull outward to
unclip.
2. Remove bottom hinge cover(s).
• Place the eraser end of a pencil or similar blunt
tool in the cover notch.
Notch
Location
Use slight pressure to
pry the cover loose.
* Continue to maintain
downward
pressure to
the notched side of the
cover while swinging
it
off.
Publicidad
