Publicidad
Idiomas disponibles
Idiomas disponibles
Reinstallation of the Door
Materials
Needed:
• Phillips screwdriver
• %_"hex head driver
1. Install hinge assemblies:
• Install top hinge loosely with _/,_" hex head
so rews.
• Install center hinge with Phillips
so rews.
• Install bottom hinge with 3/8"hex
head screws.
2. Insert bottom hinge pin.
• Locate bottom hinge hole closest
to outside edge of cabinet, and
insert bottom hinge pin. Replace
any door shims, if present.
3. Place hinge side of freezer door on bottom hinge
pin and hold freezer door
upright while installing
center
ii
hinge pin with _/,_"hex head
|.
--
r
driver.
,.
• Replace any applicable
door
shims.
• Make sure the hinge pin is
installed tightly.
4. Place hinge side of refrigerator
door on center
hinge pin.
5. While holding refrigerator
door upright, tighten
down top hinge with 5/,?,hex head driver and
replace hinge cover.
Door Reversal
In some installations,
reversing the door swing allows
for more convenient
access to stored items. Both
doors can be reversed.
1. Remove door(s} (see page 8).
2. Transfer cabinet plugs and cabinet screws to
opposite side of cabinet.
• Remove cabinet plugs with flat
blade of screwdriver
tip wrapped
in masking tape.
• Remove center mullion screws
with _/,_"hex head screwdriver.
• Remove bottom mullion screws
with 3/8"hex head driver.
To avoid
possible injury and damage
to property:
• Place doors otl a nonabrasive
surface protected
by
towels or rugs while working
directly on doors.
3. Transfer door stops from bottom edge of fresh food
door and freezer door, if applicable,
to opposite
side of door edge.
• Use a Phillips screwdriver
for removal and installation.
4. Install handles (see page 10).
5. Reinstall the door(s).
Publicidad
