Kenmore 596.65962700 Guía De Uso Y Cuidado página 8

3. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator.
B
4_
Using the carpenter's level, make sure front of
refrigerator is '/_" (6 ram) or '/_bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
Turn stabilizing legs (B) clockwise until firmly
against floor.
Replace hinge cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
7. Replace the toe grille.
Note
For proper reinstallation, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Door Removal
Some installations require door removal to transport
the refrigerator to its final location.
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
• Disconnect power to refrigerator before removing
doors. Connect power only after replacing doors.
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material.
MateriaJs Needed:
• Phillips screwdriver
• %" hex head driver
3_
Unplug power cord from
power source.
Remove toe grille (see page
7).
Remove top hinge cover
from refrigerator door by
removing Phillips screw and
retain screw and cover for
later use.
ZIt_
Unscrew -%6" hex head
screws from top hinge to
remove hinge and retain all
screws for later use.
Lift refrigerator door from
center hinge pin.
Hold freezer door while
removing hinge pin with
a -%?'hex head drivel.
Remove door from
bottom hinge and retain
hinge pin for later use.
Remove any door shims if
present.
Remove Phillips screws to
remove center hinge and
retain all screws for later
use.
8. Remove bottom hinge or
stabilizing bracket with _" hex
head driver and retain screws
for later use. Lift out bottom
hinge pin.