SAFETY
• The suitable temperature range for E330 eufyCam (Professional) and
accessories is -20°C to 45°C (-4°F - 113°F). The suitable temperature
range for S380 HomeBase and accessories is -10°C to 45°C (14°F
- 113°F). The recommended temperature range for devices and
accessories is 5°C to 25°C (41°F - 77°F).
• Unless specifically indicated that it is safe to do so in the user guide
or instruction manual, do not use this device in an environment that
exceeds the recommended low or high temperature.
• Unless specifically indicated that it is safe to do so in the user guide
or instruction manual, avoid exposing your device to direct sunlight
or wet environments.
• The power adapter should be installed near the equipment and
should be easily accessible.
• Use only a power adapter supplied by or approved by the
manufacturer. Using an unauthorized power adapter may cause
danger and may violate the authorization of the device to receive
service under warranty.
• The power adapter is for indoor use only. The plug is considered as a
disconnect device of the adapter.
Warning:
– Replacing a battery with an incorrect type may bypass safeguards
and create danger;
– Disposal of a battery in a fire or other source of significant heat, or
by crushing, or cutting, may result in an explosion as well as leakage of
flammable liquids and gases;
– Leaving a battery in an extremely hot environment may result in an
explosion as well as leakage of flammable liquids and gases;
– A battery subjected to extremely low air pressure may result in an
explosion as well as leakage of flammable liquids and gases.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO
THE INSTRUCTIONS.
CAUTION: LITHIUM COIN CELL BATTERY. KEEP BATTERIES AWAY
FROM CHILDREN. IF SWALLOWED OR PLACED INSIDE THE BODY,
BATTERIES CAN CAUSE SEVERE OR FATAL INJURIES IN 2 HOURS
OR LESS, SEEK IMMEDIATE MEDICAL CARE IF SUSPECTED.
14 EN
NOTICE
NOTICE (United States of America)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: (1) Reorient
or relocate the receiving antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure
requirements. The device can be used in fixed/mobile exposure
condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using
shielded cables to maintain compliance with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
EN 15