voestalpine bohler welding URANOS NX 2200 PMC Manual De Instrucciones página 87

Wire speed reading
757
Allow the value of the motor encoder 1 to be displayed.
Current reading (motor 1)
760
Allow the real value of the current to be displayed (motor 1).
HI heat input measurement
768
Allows reading of the value of the measurement of the heat input in welding.
EN 1011-1
Deposition rate measurement
770
Displays deposition rate measurement.
Guard limits
801
parameters.
Allows the accurate control of the various welding phases.
Refer to section "Guard limits (Set up 801)".
5.2 Specific procedures parameters
5.2.1 7 segment display personalisation
It allows you to constantly view the value of a parameter on the 7-segment display.
5.2.2 Interface personalisation (Set up 500)
Allows the parameters to be customized on the main menu.
500
A A llows the selection of the required graphic interface.
Value
XE
XA
XP
XE MODE
Welding parameters
Select the required parameter by rotating the encoder.
User interface
Easy Mode
Advanced Mode
Professional Mode
MMA
83
SETUP
.
.
EN