voestalpine bohler welding URANOS NX 2200 PMC Manual De Instrucciones página 90

SETUP
5.2.5 Circuit resistance calibration (set up 705)
Allows to calibrate the generator on the current welding circuit resistance.
EN
5.2.6 Guard limits (Set up 801)
Allows the accurate control of the various welding phases.
Refer to section "Guard limits (Set up 801)".
Warning limits
Welding current
Gas flow reading
Current reading (motor 1)
Coolant flow reading
Coolant temperature reading
Parameter selection
Select the required parameter (705).
Connect the generator to the welding circuit (bench or piece).
Remove the cap to put the nozzle holder tip of the exposed torch. (MIG/MAG)
Calibration
Place the tip of the wire guide in electrical contact with the work piece. (MIG/MAG)
Press the
Maintain contact for at least one second.
To save the change and exit the set up, press the key:
Welding voltage
Robot movement speed
Current reading (motor 2)
Wire speed reading
Parameter selection
Select the required parameter (801).
86
.
.
.
Guard limits