Solo 411 Manual Original página 6

7.1 Assembly
Assembly of the spraying wand (h):
Fig. 2
 Start the cap nut (p) evenly and screw the spray tube with the O
hand-tight without tools.
 Screw the nozzle attachment (i) onto the spray tube hand-tight without tools.
Assembly carrying belt
 Thread the upper loop of the carrying belt (k),
through one of the three attachment ribs from
above depending on body size, so that the two
clamping sliders (s) are on the outside.
 Secure the loop with the attachment pin (m)
from below.
 Thread the ends of each carrying belt through
the specified slits in the standing base (e).
 Tighten the belt.
ENGLISH 5
7.2 Length adjustment of the carrying straps
Fig. 3
Fig. 5
Pulling down the two strap ends will tighten the
carrying straps.
Fig. 6
Fig. 4
Pulling the two belt ends upwards will loosen the
carrying strap.
-
ring (16x3 mm) onto the hand valve (g)