Publicidad
Idiomas disponibles
Idiomas disponibles
7.3 Filling screen and intake screen
Fig. 7
Fig. 8
The filling screen and intake screen are required
when using the device.
7.4 Charging the battery
Before removing the rechargeable battery from the
device, always switch the on/off switch to "0"!
Fig. 9
To remove the rechargeable battery from the
device, compress the two latching levers (n) to
unlatch the battery, and then take out the battery
upwards.
The rechargeable battery needs to be charged
before you can use the pressure sprayer for the
first time.
Charging time:
Approx 2 hours
Place the charger on a stable support and connect
it to a suitable mains.
The basket in the
filling neck (c) of
the liquid tank
contains a filter
screen(r).
The intake screen is
pushed on at the intake
hose to the pump of the
spraying agent tank.
Before inserting the battery, make sure that the
contacts of the battery and the charger are clean,
dry and free of foreign objects.
Fig. 10
While the battery is charging, the LED on the
charger lights up red. Once the battery is fully
charged, the LED switches to green.
After charging, remove the battery from the charger
upwards and disconnect the charger from the
mains.
Fig. 11
Put the battery into the device in the correct
position (according to the figure) from above into
the device until you feel it click into place. Check
that the battery is secure.
7.5 Test run
Before its initial use, the sprayer should be tested
according to chapter 10.2.
Push the battery
into the charger in
the proper position
(according to the
figure).
ENGLISH 6
Publicidad
