Descargar Imprimir esta página

Busch+Müller BRIXXI 383 Instrucciones De Uso página 13

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
The prescribed assembly height in Germany is between 25 and 120 cm. More information can be found in
the traffic regulations (StVZO) or consult your local specialist retailer.
5. Package contents
Brixxi rear light I Bracket for Seat post assembly I USB-A to USB-C cable I Assembly instructions
6. Assembly
Assemble the bracket and tension band to the seat-post (25-32mm diameter) so that it will not move
out of position. Tension band
6
should be wrapped around the Seatpost and stretched over the bracket
hooks. Then press the rear light into the twist-lock bracket
When removing the rear light from the bracket, turn the twist-lock rotator slightly counter-clockwise. To
Protect the twist-lock bracket
8
from dirt when unused, please use the protection cap
protective cover
into the twist-lock fixation point.
7
24
8
, so that this fixes with an audible click.
7
. Just push the
NOTE
If the rear light does not attach in the
result from an over-stretched or displaced rear light protection cap.
This can be corrected in a few simple steps:
1. loosen screw at back of the rear light. (TX 8)
2. loosen
9
counter-part bracket
3. Adjust the soft material part to fit back into the intended seating position
4. Press
9
counter-part bracket back on to the rear light
5. Re-tighten screw so that it remains in place
!
Position the rear light so that the light emitting surface is perpendicular to the roadway (see
image on page 26). This is imperative for the correct operation of the light. The light is only
intended for assembly on the seat post.
WARNING
Never assemble on the fork or the seat stay!
To prevent falls, accidents and serious injury, use only the intended mounting bracket from Busch
and Müller. If unsuitable or ill-placed brackets are used for the assembly of lights, these can lead
to loosened or detaching parts that may trap in wheels or spokes and cause serious injury.
Please always check the secure assembly of your rear light mounting before riding.
8
twist lock bracket, or remains loose, this may
25

Publicidad

loading