Publicidad
Idiomas disponibles
Idiomas disponibles
Upside down assembly incorrect: any assembly of the rear light in an inverted upside-down position is
incorrect and the light will not function correctly.
18°
!
If the rear light is mounted upside-down, the charge indicator LED's will flash repeatedly once the light
is turned on. Only assemble as pictured.
Important: Lighting equipment must not be covered at any time.
26
Road surface
7. Charging
The rear light has a 350mAh cache battery that can be charged via the
The
USB-C port is located on the upper end of the light under the
2
To charge, use the USB cable with a standard USB charger block (max 1000mAh, 5V DC) or a
computer USB port. During charging, the
5
level of the cache battery. The
5
charge level indicator LED's will switch off when the charging
process is finished.
WARNING
As a measure of precaution, do not leave the rear light unattended while char-
ging, and always place on a fire resistant surface.
NOTE
During charging there is no splash or rain water resistance. Damage resulting from water
or humidity entering the light while charging is specifically excluded from warranty.
!
1
Replace the
light protection cap after the charging process is completed to close the
USB-C charging port. The rear light cannot attach to the
light protection cap is open.
NOTE
Open the
1
light protection cap only sufficiently to allow access to the
charging port. Overstretching the 1 light protection cap can lead to a displacement under the
counter-part bracket. To correct this, refer to point 6. Assembly.
2
USB-C charging port.
light protection cap.
1
charge level indicator will alight, showing the charge
9
counter-part bracket while the
2
USB-C
2
1
9
27
Publicidad
