Busch+Müller BRIXXI 383 Instrucciones De Uso página 15

7.1. Charge level indication
5 blue LEDs = 100 - 80 % | 4 blue LEDs = 80 - 60 % | 3 blue LEDs = 60 - 40 % |
2 blue LEDs = 40 - 20 % | 1 blue LED = 20 - 10 % | 1 blue & 1 orange LED = 10 - 5 % |
1 orange LED = < 5 %
The 5 charge level indicator will be activated by switching, or when the rear light is switched off, then
by a short press of the "on" button. When the rear light needs charging (under charge level 10%, or
when the rear light is in "safe way home" mode) the
continuously.
Once the orange LED alights together with the blue LED, then the charge level is under 10% and the
Brake function and emergency brake function will be de-activated. Please re-charge immediately.
Should the charge level sink below 5%, only the orange LED will alight, and the rear light will
automatically go into "safe way home" mode.
28
charge level indicator LED's will remain on
5
7.2. Charging times
Charging with a standard USB charger block or a computer USB port takes appr. 1.5 hrs.
While charging, the charge level indicator will alight, showing the current charge level. Once
5
the charging process is finished, the indicator LED's will go out. with a fully charged battery, the
run-time is appr. 24 hrs. This will depend on ride style, temperature and traffic situation.
8. Operation / Modes
The rear light is switched on and off with a long press of the
switch will toggle between senso-and-permanent modes.
Senso-Mode
The 4 mode indicator LED on the right side of the rear light is continuously yellow. With fading
ambient light, the rear light will automatically switch on (e.g. dark tunnel or dusk). With bright
ambient light (e.g. Daytime – Sun), the standard ride light will switch off after appr. 5 mins.
Brake and emergency brake functions remain active.
Permanent Mode
The 4 mode indicator LED on the right side of the rear light is not alight. Standard ride light
remains on continuously. Brake and emergency brake functions are active.
3 switch. A short press of the 3
29