Publicidad
Idiomas disponibles
Idiomas disponibles
24
5
Front armrest installation: as
shown in the picture A, insert it
into the groove of railing hole
(if you want to remove it just
press the button and pull out the
armrest).
6
Canopy installation: as shown in
the picture A fasten the canopy
joint on the handrails. As shown
in picture B fasten the button
on kickstand which behind the
canopy.
EN
7
Place the seat unit on to the
mounting points on both side,
push down until the button is
located n the holes of the seat
mountings, press the button on
both side to move the seat
out.
8
Connect the central locking
button restraint system as
shown in FIG. Press the button
to release it.
Sliding adjusters are fitted and
should be carefully adjusted on
each side so the harness fits
your child comfortably
A
A
B
Buckle
Button
Latch
9
Carry cot installation: installing carry cot: First just press the button and
pull out the armrest (FIG A). Position the carry cot inside the stroller, on the
inserts until you hear the "click". Always check that it is firmly in place (FIG
B~C)
WARNING: the pram body shall not be used, as soon as the child is able to
sit by himself, roll over and cannot push itself up on its hands and knees.
Maximum weight of the child: 9 kg.
A
10
Adjustable backrest: the button of the backrest regulate sliding up and down
side in the pulley can be regulation any angle adjustment with back.
WARNING: it is not suitable for baby under 6 months when the angle of the of
the back rest recline is less than 150 degrees.
B
C
25
EN
Publicidad
