Technical Specifications; Putting The Machine Into Service; Instructions For Use; Before Starting The Engine - Grillo PX31 Manual De Instrucciones

ENGINE: HONDA GCV 160 160 cm³ 4,4HP 3,3Kw @3600 r.p.m. 4-stroke one cylinder petrol
engine.
STARTER: pull-start system with recoil starter.
FUEL TANK: 0,9 litres.
HOURLY CONSUMPTION: 1,1 litres.
GEARBOX: (PX31) single gear – (PX32) 1 forward gear + 1 reverse gear.
DRIVE: with oil bath gears
CLUTCH: with active coupling
HANDLEBAR: height and side adjustable.
STANDARD ROTARY TILLER: with 4 tines and side discs for a total width of 570 mm.
WORKING WIDTH: 520 mm.
WORKING DEPTH: 280 mm.
HOES DIAMETRE: 280 mm.
ROTARY TILLER RPM: (PX31-32) forward gear 140 r.p.m. - (PX32) reverse gear 52 r.p.m.
SAFETY DEVICES: machine cut-out on release – mudguards and handlebar compliant with the
law – muffler protection.
ATTACHMENTS: rotary tiller enlargement kit up to 740 mm with side discs (working width 740
mm), rotary tiller reduction kit up to 350 mm with side discs (working width 300 mm), furrower.
TRANSFER WHEEL AS STANDARD FEATURE
WEIGHT: (PX31) 40 kg – (PX32) 42 kg
- Check that the machine has not been damaged in transit.
- Fix the handlebar with the four fixing screws (fig.5)
- Fit the transfer wheel (fig.6) using the spring and the washer
- Fix the spur (fig.7)
- Fill in the engine oil (always refer to the engine manual)
- Check the gearbox oil: if necessary use BALSIA 220 S synthetic oil, 1.5 lbs (PX31) and 1.7
lbs (PX32) (fig.4 ref. B)
- Fill the tank with fuel (fig.1 ref. 3).

BEFORE STARTING THE ENGINE

- check that the air filter is clean.
- check the engine oil level.
STARTING THE ENGINE
- Set the throttle lever in STARTER position. If the engine is cold, turn the starter lever to CHOKE
(always refer to the engine manual).
- Start the engine by pulling the pull-start handle (fig.1 no.6).
- Once the engine is running return the starter lever to RUN and the throttle lever almost to the
minimum setting.
PX31-32/ Translation of the original instructions
TECHNICAL SPECIFICATIONS PX31-32

PUTTING THE MACHINE INTO SERVICE

INSTRUCTIONS FOR USE

6