Publicidad
Idiomas disponibles
Idiomas disponibles
Functional test
Test the function before every use.
Action:
Push both handles
towards below.
Let one handle loose,
then the other.
Let both handles
loose.
& K HFNW K HR L OOHYHOEHI R U H HYHU \ X V H± VHHFKDSW H U
³ 0 DLQ W H QDQFH ³
9HQW L QJ) L J
Before working with the log splitter, vent the hydraulic
system.
• Release the venting cap 6 by a few revolutions so
the air can escape from the oil tank.
• Leave the cap open during the operation.
• Before you move the log splitter, close the cap again
in order not to lose any oil.
If the hydraulic system is not vented, the enclosed air
will damage the gaskets and with it the complete log
splitter.
6W U R N HOLPLW I R U VKR U W OR J V) L J
Lower splitting knife position about 10 cm above table.
• Move splitting knife to the desired position
• Release one operating arm
• Switch motor off
• Release the second operating arm
• Undo the star grip screw (10a)
• Push the stroke set rod (8) to the top until it is
stopped by the spring
• Tighten the star grip screw (10a) again.
• Switch motor on
• Check upper position
6Z L W F KLQJR Q DQGR ‡
Press the green button for switching on.
Press the red button for switching off.
Note: Check the function of the ON/OFF unit before
every use by switching on and off once.
26 | GB
Result:
Splitting knife goes down
to approx. 10 cm above
the table.
Splitting knife stops in the
desired position.
Splitting knife returns to
upper position.
www.scheppach.com
5HVW D U W L QJ VDI H W \ LQ FDVH R I FX U U H QW LQW H U U X S W L R Q
QR YR O W U H OHDVH
In case of current failure, inadvertent pulling of the
plug, or a defective fuse, the machine is switched off
automatically.
For switching on again, press anew the green button
of the switch unit.
Splitting
• Place the log on the table, hold it with both handles,
press the handles down. As soon as the splitting
knife enters the wood, push the handles down and
to the outside at the same time.
This prevents the wood from putting pressure on the
holder plates.
• Only split straight cut logs.
• Split the logs in vertical position.
• Never split in horizontal position or across.
• Wear protective gloves when splitting.
Attention! The lateral tray tables may not be used as
splitting support or splitting table.
( Q GR I Z R U N
• Move the splitting knife to the lower position.
• Release one operating arm.
• Switch the machine off and pull the power plug.
• Close the venting cap.
• Observe the general maintenance instructions.
11. Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
The customer's mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
• The product fulfils the requirements of
EN 61000-3-11 and may only be used at the follow-
ing connection points: This means that use of the
product at any freely selectable connection points
is not allowed.
• Given unfavourable conditions in the power supply
the product can cause the voltage to fluctuate tem-
porarily.
Publicidad
