Publicidad
Idiomas disponibles
Idiomas disponibles
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
0DO I X Q F W L R Q
The hydraulic pump
does not start
The column does not
move down
Motor starts but column
does not move down
Possible cause
No electric power
Thermal switch of motor cut off
Low oil level
One of the levers not
connected
Dirt in the rails
Wrong turning direction of
3-phase motor
www.scheppach.com
5HPHG\
Check cable for electric power
Engage thermal switch inside the motor casing
again
Check oil level and refill
Check fixing of lever
Clean the column
Check turning direction of motor and change
GB | 29
Publicidad
