Parkside PABS 20-Li G8 Traduccion Del Manual De Instrucciones Originale página 26

GB MT
Ensure that the ambient tem-
perature does not exceed
50°C or fall below -20°C du-
ring work.
Checking the battery
charge level
The battery's (8) charge level is indicated
by the charge state indicator (7).
The­LEDs­indicate­the­battery's­charge­
level, when the device is in operation.
For this, press the button for the charge
level indicator (6) on the battery.
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red => Battery needs
Recharging the battery
Allow a hot battery to cool before
charging.
Only charge the battery (8) when the
red­LED­on­the­charge­status­indicator­
(7) is on.
1. Remove the battery (8) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (8) in the charging
compartment of the battery charger (14).
3. Plug the battery charger (14) into a
mains outlet.
4. Once charging is complete, disconnect
the charger (14) from the mains supply.
5. Remove the battery (8) from the char-
ger (14).
26
to be charged
Overview of the control display on
the charger (14):
Green LED lights up without battery
inserted: Charger ready.
Green LED lights up:
Battery such alleged charged.
Red LED lights up: Battery charging.
Red LED flashes: Battery overheated.
Red + green LEDs flash:
Defective battery.
Inserting/removing the
device's battery pack
Inserting the battery pack:
1. Move the rotation direction switch (11)
onto its middle setting (lock).
2.Slide the foot of the device onto the bat-
tery pack (8) until it clicks into place.
Removing the battery pack:
1. Push the release button (9) and pull the
battery pack (8) out towards the front
of the device.
Choice of gear
Slide the gear selector (4) to 1 or 2, corre-
sponding to a low or high torque selection.
1st gear .............................0-430 min
2nd gear .........................0-1500 min
A gear change may only be per-
formed in standstill mode!
Set the direction of
rotation
You­can­select­the­direction­of­rotation­
with the direction switch (clockwise and
anticlockwise direction) and secure the de-
vice against accidental start up.
-1
-1