Publicidad
Idiomas disponibles
Idiomas disponibles
4. Installation
Read the "Safety Instructions"
section first!
B
The manufacturer will not
be liable for any event caused by
disregarding the information supplied
in this user manual.
4.1Points to be paid attention
to when the relocation
of the refrigerator
1. Your refrigerator should be
unplugged.Before transportation
of your refrigerator, it should be
emptied and cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
refrigerator should be fixed with
adhesive tape and secured against
impacts. Package should be bound
with a thick tape or sound ropes
and the transportation rules on the
package should be strictly observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the refrigerator,
Check the following before you start
to use your refrigerator:
1. Clean the interior of the
refrigerator as recommended in the
"Maintenance and cleaning" section.
2. Connect the plug of the refrigerator
to the wall socket. When the fridge
door is opened, fridge internal lamp
will turn on.
3. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give
rise to noise, even if the compressor
12
is not running and this is quite
normal.
4. Front edges of the refrigerator may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
4.2 Electrical connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in
compliance with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your
refrigerator shall be guaranteed
only if the earth system in your
house complies with standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
• Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must
be replaced by a qualified electrician.
B
Product must not be operated
before it is repaired! There is the risk
of electric shock!
Publicidad
