Bosch PWS 700-115 Manual Original página 20

20 | English
Intended use
The power tool is intended for cutting and brushing metal,
stone, plastics and composite materials, for roughing metal,
plastics and composite materials without the use of water.
Make sure that the correct protective guard is used (see "Op-
eration", page 23).
Sufficient dust extraction must be provided when cutting
stone.
With approved abrasive tools, the power tool can be used for
sanding with sanding discs.
The power tool must not be used to grind stone materials
with diamond grinding heads.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Unlocking lever for protective guard
(2) Spindle lock button
(3) On/off switch
(4) Standard auxiliary handle (insulated gripping sur-
face)
(5) Grinding spindle
(6) Protective guard for grinding
Technical Data
Angle grinder
Article number
Rated power input
A)
Rated no-load speed
Max. grinding disc diameter/rubber sanding
pad diameter
Grinding spindle thread
Max. thread length of grinding spindle
Restart protection
Weight according to EPTA-Proced-
B)
ure 01:2014
Protection class
A) Rated no-load speed for the selection of appropriate application tools in accordance with EN IEC 62841-2-3. The actual no-load speed is
lower for safety reasons and according to production tolerances.
B) Depends on protective guard and auxiliary handle in use
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Angle grinder
Article number
Rated power input
A)
Rated no-load speed
Max. grinding disc diameter/rubber sanding pad diameter
Grinding spindle thread
Max. thread length of grinding spindle
1 609 92A 75G | (14.02.2023)
(7) Mounting flange
(8) Grinding disc
(9) Clamping nut
(10) Protective guard for cutting
(11) Cutting disc
(12) Hand guard
(13) Rubber sanding pad
(14) Abrasive disc
a)
(15) Round nut
a)
(16) Cup brush
(17) Extraction guard for cutting with cutting guides
(18) Diamond cutting disc
(19) Handle (insulated gripping surface)
(20) Direction of rotation arrow on housing
(21) Two-pin spanner for clamping nut/round nut
(22) Low-vibration auxiliary handle (insulated gripping
a)
surface)
(23) Open-ended spanner
(24) Cover for cutting
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
PWS 700-115 PWS 700-125 PWS 750-115 PWS 750-125
3 603 CA2 4.. 3 603 CA2 4..
W 701
-1
min 12000
mm 115
M 14
mm 21
●
kg 1.8
/ II
a)
a)
a)
a)
a)
a)
a)
a)
3 603 CA2 4.. 3 603 CA2 4..
701 750
12000 12000
125 115
M 14 M 14
21 21
● ●
1.9 1.9
/ II / II
PWS 850-125 PWS 8500-125
3 603 CA2 7.. 3 603 CA2 7..
W 850
-1
min 12000
mm 125
M 14
mm 21
Bosch Power Tools
a)
a)
750
12000
125
M 14
21
●
1.9
/ II
850
12000
125
M 14
21