Publicidad
Idiomas disponibles
Idiomas disponibles
External View
X
CO
Dimensions
Width
447 mm (17 60")
Height
461 mm (18 15")
Depth
247 mm ( 9 72")
Depth w / 30 degree tilt angle 271 mm (10 67")
Tilt range
Down
0 degrees
Up
30 degrees
— Caution -
When adjusting the vertical angle of the LCD monitor, firmly grasp the top of the monitor with one
hand and the bottom with the other Then, slowly move the monitor to the desired angle
Do not press on the upper part of the LCD as this may cause the unit to fail down
(5
LU
Installation
■ Connecting Preparation
Remove the cable covers in advance as shown below
© Pull the left cable cover to the LCD panel side as shown in Figure 1 When the cover becomes
unlocked, remove by sliding in the direction indicated in Figure 2 Remove the nght cable cover in
the same manner
© To protect the surface of LCD panel, place a towel (or other suitable cushion) on the work
surface Carefully turn the monitor face-down and gently place it on top of the towel To make it
easier to connect, adjust the angle of the stand
© Remove the back cable cover by pulling the parts labeled "Pull to open"
I— Caution-
When carrying, always hold the main unit section Do not hold the stand or the stand post
,
Figure 1
7
Publicidad
