Descargar Imprimir esta página

SEVERIN FR 2440 Instrucciones De Uso página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
∙ Let the appliance cool down sufficiently
before moving it.
∙ Always remove the plug from the wall
socket
- after use,
- in case of any malfunction, and
- before cleaning the appliance.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ Do not use metal kitchen utensils
when adding or removing food, so as
to avoid scratching the surface.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Intended use
∙ This appliance must only be used for
cooking food. Any other use must be
considered improper and may lead to
personal injuries or material damage.
∙ Unlike conventional deep-fryers, this
appliance is not intended to be used
with oil or fat.
Before using for the first time
∙ Before using the appliance for the first
time, remove any remaining packaging
materials and stickers.
∙ Heat the appliance for 15 minutes to
200 °C without any food. This will lessen
the inherent smell of the appliance (see
Using the manual temperature / time
selection).
∙ Ensure adequate ventilation by opening
windows or balcony doors.
∙ Clean the appliance afterwards as
described in Cleaning and care.
14
Preparing the unit
1.
Always place the unit on a dry, level,
non-slip and heat-resistant surface
impervious to contact with the rubber
feet.
2.
Prepare the food to be air-fried.
3.
Insert the plug into the socket.
4.
Put the food into the basket with the
holder fitted. Make sure you do not
exceed the 'MAX' marking.
5.
Install the basket holder in the
appliance. If it is fitted correctly, a
beep signal is heard and the display
flashes briefly. Without the holder
fitted, the appliance cannot be
operated.
6.
Press the
key for 2 seconds to
turn the fryer on. To switch off, press it
again for 2 seconds.
Using automatic programmes
1.
Proceed as described under Preparing
the unit (1-6) and tap the
Ü The first automatic programme
shows on the display.
2.
Keep tapping the menu key
the desired programme is shown.
Temperature and time alternate in the
display.
3.
Tap the
key.
Ü The food is now being cooked. The
display changes between temperature
and remaining running time. Audible
beeps indicate that the pre-set
processing time has elapsed.
key.
until

Publicidad

loading