Princess 2607 Instrucciones De Uso página 10

• To avoid condensation, do not fit the
lid to the appliance whilst heating the
fat or frying food. See Figure 3.
• Make sure that the food is thoroughly
dry before you fry it. Moist products
can cause severe splashing of the oil
or fat.
• To avoid splashing oil or fat remove as
much ice as possible from frozen food
before frying.
• Do not put too much food in the frying
basket at one time.
1 Put the plug into the wall socket.
2 Turn the thermostat dial to the required
setting. See 'Directions for frying times
and temperatures'. The indicator light
will illuminate. This indicator light shows
that the heating element has been
switched on and the required
temperature has not yet been achieved.
The required temperature has been
attained once the indicator light
extinguishes.
3 Remove the frying basket from the
bowl. Put the food into the frying
basket, and carefully lower it into the
bowl.
4 Take the frying bowl out of the bowl
once the food is cooked. You can use
the hook fitted to the frying basket to
hang it on the inner rim of the bowl (see
Figure 4); the excess oil can then drip
from the frying basket.
5 Put the food onto a plate, preferably on
a sheet of paper kitchen towel.
6 Before frying a fresh portion check that
the temperature indicator light is
extinguished. If it is illuminated wait
until it extinguishes.
7 When you have finished frying put the
frying basket back into the bowl.
8 Place the lid on the bowl.
9 Switch off the deep fryer by turning the
temperature adjustment dial to the
'MIN' position.
10 Remove the plug from the wall socket.
8 New Classics Deep Fryer Article 2607
Maintenance
and cleaning
1 Remove the plug from the wall socket,
and allow the appliance to cool down
completely.
2 Remove the lids and the frying basket
from the appliance. Clean them in hot
washing-up solution or place them in a
dishwasher, and then dry thoroughly.
3 Remove the control panel with the
heating elements from the appliance.
Carefully clean the heating elements
with hot washing-up water, and then dry
them thoroughly. Clean the control
panel with the special microfibre cloth
supplied with the appliance. Do not
moisten the cloth.
4 Remove the bowl from the appliance
and pour the oil or fat into a receptacle.
Dry the bowl with paper kitchen towel
and clean it in hot washing-up water, or
place in a dishwasher. Dry the bowl
thoroughly.
5 Clean the exterior of the housing with
the microfibre cloth.
6 Open the cover of the cord holder and
store the cord. See Figure 5.
• Never move the appliance whilst it is
switched on or is still hot. Switch off
the appliance, and wait until it has
cooled down before you move it.
• Make sure no moisture gets into the
appliance.
• Do not immerse the appliance in
water, or in other liquids. If this
happens do not use the appliance any
more; for safety reasons, dispose of
the appliance.
• Never use corrosive or scouring
cleaning agents.