Descargar Imprimir esta página

Bosch Climate 2000 Manual De Servicio Para El Usuario página 24

Ocultar thumbs Ver también para Climate 2000:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Operation
3.3
Using the remote control
The signal range is 8 m. If objects are in the way or certain fluorescent
lamps are used in the same room this can affect transmission of the
signal.
▶ Point the remote control towards the signal receiver window of the
device and press the desired key.
The device emits a beep when it receives a signal.
NOTICE
The remote control may be permanently prevented from working
correctly.
▶ Do not expose the remote control to direct sunlight.
▶ Do not leave the remote control near a heating appliance.
▶ Protect the remote control from moisture and impacts.
3.4
Setting main operating mode
Turn unit on/off
▶ Press the K key to switch the device on or off:
The device starts in the set operating mode.
Settings can also be made when the device is switched off. The device
saves the settings, and also retains them in the event of a power failure.
Automatic mode
In automatic mode, the device automatically switches between heating
and cooling mode to maintain the desired temperature.
▶ Press the Mode key repeatedly until
▶ Select the required temperature with the . and / keys.
The fan speed cannot be adjusted in automatic mode.
Cooling mode
▶ Press the Mode key repeatedly until
▶ Press the
key until the required air speed is reached.
▶ Select the required temperature with the . and / keys.
Fan (Only) Mode
▶ Press the Mode key repeatedly until
▶ Press the
key until the required fan speed is reached. AUTO can
be selected to enable automatic control.
The temperature cannot be adjusted or displayed in Fan Mode.
Dehumidification mode
▶ Press the Mode key repeatedly until
▶ Set the required temperature with the . and / keys.
The fan speed cannot be adjusted in dehumidification mode.
Heat mode
▶ Press and hold the Mode key until
▶ Set the required temperature with the . and / keys.
▶ Press the
key until the required air speed is reached.
If the outside temperature is very low, the heating capacity of the air
conditioning system may not be sufficient. We recommend connecting
additional heat sources.
24
appears on the display.
appears on the display.
appears on the display.
appears on the display.
appears on the display.
3.5
Setting timer
ON and OFF timers can be set to between 0 and 24 hours, in 30-minute
increments for the first 10 hours, then in 1-hour increments. If 0 hours is
set, the timer is cancelled.
Setting the on timer
▶ Press the
key until the
▶ Press the . or / key to set the desired time.
The setting is applied shortly afterwards.
Setting the off timer
▶ Press the
key until the
▶ Press the . or / key to set the desired time.
The setting is applied shortly afterwards.
Cancelling timer
▶ Press the
key to select the corresponding timer.
▶ Set 0.0 hours.
The timer is cancelled after a short time.
Combining timers
The two timers can be set at the same time. Either timer can be
programmed to activate prior to the other
▶ Set the on timer and off timer.
The settings will be automatically combined.
Current time
Setting of ON timer
Setting of OFF timer
Switch-on time
Switch-off time
Table 35 Example
You can not program the on timer and off timer to operate the unit at
different temperatures or with other settings.
3.6
Other functions
3.6.1
Setting the swing function
NOTICE
If the louvre remains at the lowest position during cooling mode for an
extended period, condensate may be discharged. Adjusting the louvres
vertically by hand may cause faults.
▶ Only use the remote control to adjust the louvres vertically.
Swinging horizontally (left/right)
The horizontal position must be set by hand.
▶ Switch off the indoor unit and disconnect the power supply.
▶ Flip down the air baffle ( Fig. 2).
▶ Swivel the louvres horizontally by hand into the required position.
▶ Put the air baffle back in the original position.
Automatic vertical Swing mode (up/down)
▶ Press the Swing key for longer than 2 seconds to activate the
automatic vertical Swing mode.
The remote control displays the symbol
▶ To cancel the automatic vertical Swing mode: press the Swing key
again.
Cleaning position
To make cleaning easier, the louvre can be brought into a special position
(depending on product type).
symbol appears.
symbol appears.
13:00 o'clock
4.0 h
8.5 h
17:00 o'clock
21:30 o'clock
.
Climate 2000 – 6721852026 (2023/05)

Publicidad

loading

Este manual también es adecuado para:

Cl2000u w 26 eCl2000u w 35 eCl2000u w 53 eCl2000u w 70 eCl2000 26 eCl2000 35 e ... Mostrar todo