Publicidad
Idiomas disponibles
Idiomas disponibles
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1
Insulated grip surfaces
2
On/off switch
3
Speed setting button
4
Speed control panel
5
Extraction nozzle
6
Sanding plate
7
Sanding sheet
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power
tool
Pull out the mains plug and check that there
are no missing or damaged parts.
Attaching/changing the sanding
sheet
The sanding plate has Velcro fasteners and is
therefore designed exclusively for use with
Velcro sanding sheet (see figure C).
■ Pull out the mains plug.
■ Remove used sanding sheet 7.
■ Remove any coarse debris from the sanding
plate 6.
■ Attach new sanding sheet. Align the holes
in the sanding sheet with the holes in the
sanding plate 6.
■ Attach the sanding sheet by gently pressing
it against the Velcro fasteners on the
sanding plate 6.
Changing the sanding plate
If the sanding plate 6 has worn out, it can be
replaced (see figure D).
■ Pull out the mains plug.
■ Undo the eight screws.
■ Remove the sanding plate 6 by pulling it
downwards.
12
■ Attach a new sanding plate.
■ Tighten the eight screws back.
Setting the speed
There are four speed levels that can be
changed using the speed setting buttons 3.
The LED lights above the numbers indicate
the current speed level (see figure E).
The speed level can be set when the tool is
connected to the power supply or when the
tool is already in operation. After you turn the
tool off, the memory function will remember
and revert to the last active speed level the
next time the tool is turned on.
Switching on and off
Switch power tool on or off by pressing on/off
switch 2 (see figure F).
CAUTION!
Following a power failure, the switched-on
power tool will not start running again.
Operating instructions
WARNING!
Hold the electric power tool by the insulated
grip surfaces only!
CAUTION!
When the power tool is switched off, the
grinding tool continues running briefly.
– Switch on the sander and place the
whole sanding sheet on the surface to be
processed.
– Applying moderate pressure, move the
sander evenly over the workpiece.
– The sanding result is determined primarily
by the selection of the correct sanding sheet,
the selected number of oscillations and the
contact pressure.
– Replace sanding sheets in good time.
– An excessive increase in the contact pressure
will not increase the grinding performance,
but will increase the wear on the electric
power tool and the sanding tool.
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
OSE 2-70x198-EC
Publicidad
