Publicidad
Idiomas disponibles
Idiomas disponibles
4. WIRING DIAGRAM AND INTERNAL BOARD
Inputs
Description
L, N, GND (J1)
Power supply. 220-230 V AC 50 Hz
Pressure tap 1
Tap to connect duct pressure depending on operation mode
Pressure tap 2
RJ45 (J9)
PROSYS CTBH accessory console connection
Outputs
Description
Internal board power supply passing through ON/OFF switch (Factory wired)
GND, N,
(J2)
RELÉ (J3)
Commutate if any alarm is activated (2A maximum load)
0V, +V (J7)
Output analog signal 0-10V to the motor
TACOM (J8)
Pulse motor
A, B (J10)
Network connection. Modbus protocol
RS485 (J12)
Network connection. Modbus protocol
Micro switches
Description
SW1
End of line resistor. Exclusive use for Modbus communication network
SW2
SW2-2: enable channel change
EN
17
Publicidad
