Publicidad
Idiomas disponibles
Idiomas disponibles
MENU STRUCTURE
To access the monitoring parameters, press the wheel
on the face of the frequency drive. Using the wheel,
scroll through the list until the display shows Non (Mon)
for monitoring mode. This gives the user access to all the
monitoring parameters.
ENT
MONITORING PARAMETERS
CODE
NAME/DESCRIPTION
LFr
External Reference Value:
External keypad or local force mode configured. Forced local reference FLOC set to LCC and forced local
assignment FLO different to nO. Displays the speed reference coming from the remote keypad. This value is not
visible in factory setting.
rFr
Output Frequency:
This function provides the estimated motor speed. It corresponds to the estimated motor frequency (on the motor
shaft). In standard law the output frequency rFr is equal to stator frequency. In performance law the output
frequency rFr motor speed is equal to the estimated motor speed.
Range: -400 to 400 Hz
LCr
Motor Current:
Estimation of the effective motor current from phase current measurements with an accuracy of 5%. During DC
injection, the current displayed is the maximum value of current injected in the motor.
ULn
Main Voltage:
Line voltage from the point of view of the DC bus, motor running or stopped.
CODE
NAME/DESCRIPTION
StAt
ß Product Status
This parameter shows the state of the drive and motor.
ß
Drive ready.
rdY
ß
Drive running, the last six segments to the right of the code also indicate direction and speed.
rUn
ß
Acceleration, the last six segments to the right of the code also indicate direction and speed.
ACC
ß
Deceleration, the last six segments to the right of the code also indicate direction and speed.
dEc
ß
DC injection braking in progress.
dCb
ß
Current limit, the four segments located on right down of display are blinking.
CLl
ß
Freewheel stop control.
nSt
ß
Auto-adapted deceleration.
Obr
ß
Controlled stop on mains phase loss.
CtL
ß
Auto-tuning in progress.
tUn
ß
Fast stop.
FSt
ß
No line power. When the control part is energized via the RJ45 connector and there is no power on the main input and
nLP
no run order is present.
PAGE 6 OF 51
FREQUENCY DRIVE CONTINUED
To access the complete set of drive parameters first
press the wheel to access different modes. Using the
wheel, scroll to "COnF" and press the wheel again; this
will access different sets of parameters. Using the wheel,
scroll to "FULL" and press the wheel; this will give the user
access to the complete parameter set.
UNIT
Hz
Hz
A
A
1023 IH-8923
Publicidad
