Progress Lighting P250110 Manual De Instalación página 9

Make the Electrical
Connections
WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse
box before wiring.
WARNING: Check to see that all connections are
tight, including ground, and that no bare wire is
visible at the wire nuts, except for the ground wire.
CAUTION: To reduce the risk of electric shock,
this fan must be installed with an isolating wall
control/switch.
NOTE: The fan must be installed at a maximum
distance of 20 ft. from the remote control for proper
signal transmission between the remote control
and the fan's receiving unit.
If you feel you do not have enough electrical wiring
knowledge or experience, have your fan installed
by a licensed electrician.
Follow the steps below to connect the fan to your
household wiring. Use the plastic wire nuts with your
fan. Secure the plastic wire nuts with electrical tape.
Make sure there are no loose strands or
connections.
Step 1. Insert the receiver into the mounting
bracket with the flat side of the receiver facing the
ceiling. (Fig. 9)
Step 2. Make wire connections from the fan to the
receiver. (Fig. 10)
From Fan To Receiver
White Wire ----------- White Wire "For Light"
Blue Wire ------------ Blue Wire "For Light"
Yellow Wire --------- Yellow Wire
Red Wire ------------- Red Wire
------------
Grey Wire Grey Wire
Step 3. Make wire connections from the receiver
to the outlet box. (Fig. 10)
From Receiver To Outlet Box
-----
Black Wire "AC in L" Black Wire (Hot)
-----
White Wire "AC in N" White Wire (Neutral)
From Fan & To Outlet Box
Receiver
Green Wires* ------ Green or Bare Wire (Ground)
* There are three green grounding leads: from the
mounting bracket, hanger ball/downrod assembly,
receiver.
Step 4. Turn the wire nut connections upward,
spreading them apart so the green (ground) and
white wires will be on one side of the outlet box
and the black and blue wires will be on the other
side. Carefully tuck the connections up into the
outlet box.
Receiver
Figure 9
White (Neutral)
Black (Hot)
Outlet Box
White ("AC IN N")
Black ("AC IN L")
Receiver
White
Blue
Yellow
Red
Grey
Grey
Red
Yellow
Blue
White
Canopy
Hanger
bracket
Figure 10
Ground conductor
Green
Green
Green
Green
6.