Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
•
If the parts are damaged, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2
ATTACH THE EDGE GUIDE
The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Insert the edge guide (12) into the two holes on the
housing for fitment.
12
2. The edge guide can be flipped up for storage.
8.3
ATTACH THE GUARD
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
NOTE
English
3. Align the screw holes on the guard (11) with the screw
holes (4) on the trimmer head.
4. Tighten the screws.
11
8.4
ASSEMBLE THE SHAFT
1. Loosen the knob (8) on the coupler (7).
2. Push in the release button (13) on the lower shaft (9).
3. Align the release button with the positioning hole (14)
and move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
14
9
13
8.5
ATTACH THE AUXILIARY
HANDLE
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle (5) and lower clamp (15) on
the shaft.
7
4
14
8
EN
7
Publicidad
