Soundoff Signal MpoWer EMPS2QM Serie Manual Del Usuario página 12

4" & 3" MPOWER FASCIA LIGHTS
®
ELECTRICAL INSTRUCTIONS CONTINUED:
Connecting the Green wire to ground before applying power
to the Red or Red/White wires will place the LED module
into remote mode and the light output color will be directly
controlled by the input wires as shown below.
Red/White
Red Wire
Wire
Cruise -
- Cruise
Cruise Cruise
Flash -
- Flash
Flash Flash
Steady ON -
- Steady ON
Steady ON Steady ON
Cruise Flash
Cruise Steady ON
Flash Steady ON
Cruise and Low Power Modes
For Cruise mode or Low Power control of the LED module,
the signal to the control wires must be 100 +/- 2Hz using
the duty cycle inputs listed below to produce the light
output.
Cruise Mode Duty Cycle (@ 100Hz)
Input
40%
50%
60%
12
1.800.338.7337 / www.soundoffsignal.com
REMOTE MODE: FOR USE WITH bluePRINT SYSTEM ONLY
mpower® Secondary LED Light Remote Mode Functionality
Single Color
Color Color
Swap=OFF Swap=ON
Cruise Color 1
Flash Color 1
Steady ON Color 1
Light Output
OFF
5%
10%
Dual Color
Color Color
Swap=OFF Swap=ON
Cruise Color 1 Cruise Color 2
Cruise Color 1
Cruise Color 2
Cruise Color 1
Cruise Color 2
Flash Color 2
Flash Color 1
Flash Color 1
Flash Color 2
Flash Color 1
Flash Color 2
Steady ON Color 2
Steady ON Color 1
Steady ON Color 1
Steady ON Color 2
Steady ON Color 1
Steady ON Color 2
Flash Color 1/Cruise
Flash Color 2/Cruise
Color 2 during OFF
Color 1 during OFF
cycle of Flash
cycle of Flash
Steady ON Color 1
Steady ON Color 2
Steady ON Color 1
Steady ON Color 2
Low Power Flash D.C. (@ 100Hz)
Input
70%
80%
90%
Tri Color
Color Color
Swap=OFF Swap=ON
Cruise Color 1 Cruise Color 2
Cruise Color 2 Cruise Color 1
Cruise Color 3 Cruise Color 3
Flash Color 1 Flash Color 2
Flash Color 2 Flash Color 1
Flash Color 3 Flash Color 3
Steady ON Color 1 Steady ON Color 2
Steady ON Color 2 Steady ON Color 1
Steady ON Color 3 Steady ON Color 3
Light Output
30%
40%
50%
4" & 3" MPOWER FASCIA LIGHTS
®
ENGLISH 0000JL 1123 REV C