Descargar Imprimir esta página

Soundoff Signal MpoWer EMPS2QM Serie Manual Del Usuario página 6

Ocultar thumbs Ver también para MpoWer EMPS2QM Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

4" & 3" MPOWER
FASCIA LIGHTS
®
MULTI-MOUNT INSTALLATION:
Multi-Mount Bracket (FIG. 1) P/N: PMP2BKDGAJ
1. Pre-drill mount holes as required (bracket holes and
spacing are indicated on page 7 (4") or page 8 (3").
2. Place bracket onto desired vehicle's surface and secure
with screws (not provided).
3. Install Heat Sink onto "mPOWER Stud Mount, Threaded"
light as indicated. Wire passes through center hole.
4. Install "mPOWER Stud Mount, Thread" light onto bracket
as indicated. Wire passes though rear relief.
5. Install 2 lock nuts onto "mPOWER Stuf Mount, Thread"
light as indicated. Hand tighten until final adjustment.
6. Adjust angle of light to desired direction and tighten 2
lock nuts until secure. After the nut makes full contact
with the mounting surface, hand tighten 1/8th turn
(torque no more than 15 in-lbs.)
7. Make wire connections.
GRILLE MOUNT BACKPLATE INSTALLATION:
Grille Mount Backplate (FIG. 2) P/N: PMP2BKGBPB
1. Pre-drill mount holes as required (bracket holes and
spacing are indicated on page 7 (4") or page 8 (3").
2. Place bracket onto desired vehicle's surface and secure
with screws (not provided).
3. Install Heat Sink onto "mPOWER Stud Mount" light as
indicated. Wire passes through center hole.
4. Install "mPOWER Stud Mount" light onto bracket as
indicated. Wire passes though rear relief.
5. Install 2 lock nuts onto "mPOWER Stud Mount" light as
indicated. Hand tighten until final adjustment.
6. Adjust angle of light to desired direction and tighten 2
lock nuts until secure. After the nut makes full contact
with the mounting surface, hand tighten 1/8th turn
(torque no more than 15 in-lbs.)
7. Make wire connections.
6
1.800.338.7337 / www.soundoffsignal.com
DO NOT USE POWER
TOOLS TO TIGHTEN
DO NOT USE POWER
TOOLS TO TIGHTEN
FIG. 1
FIG. 1
STUD MOUNT - THREADED LIGHT
THREADED STUD X 2
90°±15° EDGE MOUNT BRACKET
MULTI-MOUNT
FIG. 2
FIG. 2
THREADED STUD x2
MOUNT SURFACE
*FOR USE WITH STUF MOUNT MPOWERS ONLY
GRILLE MOUNT BRACKET
HEAT SINK
LOCKNUT X 2
WIRE HOLE
4" & 3" MPOWER
FASCIA LIGHTS
®
ENGLISH 0000JL 1123 REV C

Publicidad

loading