Publicidad
Idiomas disponibles
Idiomas disponibles
4" & 3" MPOWER
FASCIA LIGHTS
®
SCREW MOUNT INSTALLATION:
Screw Mount (FIG 3)
1. Pre-Drill per screw mount pattern indicated on page 7
(4") or page 8 (3".)
2. Deburr and clean the surface, as required.
3. Make wire connections and feed the wire through the
drilled wire hole.
4. Install light with 2x Torx drive screws and hand tighten
only until mount surface and light are flush.
WARNING
!
PETROLEUM/SILICONE BASED
LUBRICANTS WILL CAUSE THE
SILICONE LENS TO DISCOLOR.
EDGE MOUNT INSTALLATION:
Edge-Mount Bracket (FIG. 4) P/N: PMP2BKEDGE
1. Install Heat Sink onto "mPOWER Stud Mount,
Threaded" light as ndicated. Wire passed through
center hole.
2. Install bracket onto "mPOWER Stud Mount, Thread"
light as indicated. Wire passed through rear relief and
into lower edge grip relief.
3. Install 2 lock nuts onto "mPOWER Stud Mount, Thread"
light. Hand tighten until final adjustment.
4. Place bracket over desired vehicle's edge surface (i.e.
rear hood), ensure wire is fully seated in rear relief,
wrapping around edge lying flat.
5. Tighten 2 setscrews to vehicle's edge surface.
6. Adjust angle of light to desired direction and tighten 2
lock nuts until secure. After the nut makes full contact
with the mounting surface, hand tighten 1/8th turn
(torque no more than 15 in-lbs.)
7. Make wire connections.
5
1.800.338.7337 / www.soundoffsignal.com
DO NOT USE POWER
TOOLS TO TIGHTEN
DO NOT USE POWER
TOOLS TO TIGHTEN
FIG. 3
FIG. 3
SCREW MOUNT
FIG. 4
FIG. 4
THREADED STUD X 2
90°±15° EDGE MOUNT BRACKET
EDGE MOUNT BRACKET
TORX DRIVE SCREWS x2
STUD MOUNT - THREADED LIGHT
HEAT SINK
LOCKNUT X 2
SETSCREW X 2
4" & 3" MPOWER
FASCIA LIGHTS
®
ENGLISH 0000JL 1123 REV C
Publicidad
