Black and Decker SmartSelect BDPH1200 Manual De Instrucciones página 35

TROUBLE! MATERIAL RUNS OR DRIPS.
WHAT'S WRONG?
Spraying too much material.
Spraying too slowly.
Spraying too close.
Viscosity too thin.
TROUBLE! MATERIAL DRIPS FROM NOZZLE
WHAT'S WRONG?
Nozzle loose.
Nozzle breaks.
Y-type seal ring of nozzle breaks.
Material accumulated /clog inside nozzle.
TROUBLE! TOO MUCH OVER SPRAY.
WHAT'S WRONG?
Sprayer too far from surface.
Too much material being sprayed.
TROUBLE! LITTLE OR NO MATERIAL BEING RELEASED.
WHAT'S WRONG?
Spray nozzle/tip clogged.
Y-type seal ring of nozzle missing
Pickup tube loose or clogged.
Canister loose
Quick refill lid loose
Air hose split or disconnected
Flow control knob setting too low.
Air inlet blocked.
Material too thick.
TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING.
WHAT'S WRONG?
Viscosity of material is too high.
TROUBLE! ATOMIZATION IS TOO COARSE
WHAT'S WRONG?
Viscosity of material too high.
Flow control knob setting too high.
Material accumulated /clog inside nozzle.
Air inlet blocked.
Canister loose.
Quick refill lid loose.
TROUBLESHOOTING
WHAT TO DO...
Reduce air flow by turning material adjustment knob.
Increase speed of application.
Increase distance from surface.
Check dilution recommendation.
WHAT TO DO...
Screw nozzle tight
Change
Change
Clean
WHAT TO DO...
Reduce distance to surface.
Reduce air flow by turning material adjustment knob.
WHAT TO DO...
Clean nozzles.
Add seal ring to nozzle and assemble in place
Check tube.
Screw canister tightly in place
Screw canister tightly in place
Check air hose
Increase flow control setting.
Clean or change air filter.
Check viscosity recommendation
WHAT TO DO...
Thin material per manufacturer recommendation.
WHAT TO DO...
Thin material per manufacturer recommendation.
Decrease flow control setting.
Clean
Clean or change air filter
Screw canister tightly in place
Screw quick refill lid tight in place