Publicidad
Idiomas disponibles
Idiomas disponibles
Table of Contents
Precautions
Functions of Controls
Adjustments ....
Preset Modes
Power Saving Function...
Use of the Tilt-Swivel
Damper Wire
Specifications
Troubleshooting
Precautions
e Prevent internal heat build-up by allowing adequate air
e Clean the cabinet, panel and controls with a soft cloth
circulation. Do not place the unit on surfaces (rugs,
lightly moistened with a mild detergent solution. Do not
blankets, etc.) nor near materials (curtains, draperies) that
use any type of abrasive pad, scouring powder or solvent,
may block the ventilation holes.
such as alcohol or benzine.
¢ Do not install the unit near heat sources such as radiators
¢ Do not rub, touch, or tap the surface of the screen with
or air ducts, nor in a place subject to direct sunlight,
sharp or abrasive items, like a ball point pen or a screw
excessive dust, mechanical vibration or shock.
driver. Otherwise, this type of contact may result in a
¢ Do not place the unit near equipment which generates
scratched picture tube.
[EN
|
magnetism, such as a converter or high voltage power
lines.
e Use a proper power cord for your local power supply.
Examples of plug shape:
LI 7 7y
f
—
G
©
RS
Se SS
for 100 to 120 V AC
for 220 to 240 V AC
¢ To disconnect the power cord, wait for at least 30 seconds
after turning off the power for discharging the static
electricity on the CRT display surface.
e After the power has been turned on, the CRT is
demagnetized for approximately 5 seconds. This
generates a strong magnetic field around the bezel, which
may affect the data stored on magnetic tapes or disks near
the bezel. Place such magnetic recording equipment and
tapes/disks apart from this unit.
The socket-outlet should be installed near the equipment
and be easily accessible.
Publicidad
