Descargar Imprimir esta página

AGV K3 Manual Del Usuario página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79
5 PINLOCK
A hydrophilic plastic device with anti-fog features capable of absorbing humidity.
By fitting precisely into the specially shaped seat on the inner surface of the visor,
it creates an air pocket that limits the onset of fogging without compromising the
field of view.
Anti-fog devices delay the formation of condensation, but do not guarantee that the
problem will not occur. Such devices delay the onset of the problem. Therefore, under
extreme environmental conditions, fogging of the visor may occur.
It is strongly recommended the use of Pinlock
and/or humidity levels above 70% and/or in the rain.
The Pinlock
scratch it or abrade its surface.
5.1 INSTALLATION
Prerequisite: the visor is removed from the helmet (see 3.2) and has been thoroughly cleaned. The lens
is resting on the inner surface of the visor, facing so that the silicone gasket is in contact with the visor.
Stretch the visor slightly by grasping it at the ends
Attach the lens
Ensure that the silicone gasket
length
.
2
Remove the protective film from the lens and install the visor on the helmet (see 3.2).
12
®
lens should be handled with care and without the use of tools that could
®
to the eccentric pawls
A
of the lens adheres perfectly to the visor along its entire
C
1
ANTI-FOG LENS
lens with air temperatures below 20°C
®
.
1
of the visor; first on one side, then on the other.
B
B
C
A
2

Publicidad

loading