Before Operating; To Set The Clock; Timer; Stop/Clear - Gaggenau MW 420 620 Manual De Instrucciones

Before operating

Before operating your new Microwave Built-in Drawer
make sure you read and understand this operation
manual completely.
z z Before the Microwave Built-in Drawer can be used,
follow these steps:
1 Plug in the Microwave Built-in Drawer.
MICRO-
WAVE TOUCH
will appear.
CLOCK
Touch the Stop/cLear pad.
2
3 Set clock.

to Set the clock

Touch tIMer/cLocK pad and number 2
1
2 Touch number pads for correct time of day and touch
tIMer/cLocK pad again.
This is a 12 hour clock. If you attempt to enter an
incorrect clock time,
ERROR
Touch the Stop/cLear pad and re-enter the time.
z z If the electrical power supply to your Microwave
Built-in Drawer should be interrupted, the display will
intermittently show
ENJOY
TOUCH CLEAR AND
power is reinstated. If this occurs during cooking, the
program will be erased. The time of day will also be
erased. Simply touch Stop/cLear pad and reset the
clock for the correct time of day.
note:
z z
The Microwave Built-in Drawer can be programmed
with the drawer open except for Start (+1 MIn).

timer

1 Touch tIMer/cLocK pad and number
2 Enter time.
3 Touch tIMer/cLocK pad again.
To cancel timer, touch Stop/cLear.
8
ENJOY YOUR
CLEAR AND TOUCH
will appear.
:
will appear in the display.
YOUR MICRO-
WAVE
after the
TOUCH CLOCK
.
1

Stop/clear

Touch the Stop/cLear pad to:
z z
Erase if you make a mistake during programming.
z z
Cancel timer.
z z
Stop the Microwave Built-in Drawer temporarily during
timed cooking.
z z
Return the time of day to the display.
z z
Cancel a program during cooking; touch twice for
timed cooking.
open or close Microwave Built-in
Drawer
Always press the Open or Close key on the control panel
to open or close the drawer.
Do not push or pull the drawer by hand, except in case of
emergency, such as during a power failure. If necessary,
push or pull slowly.
note:
If the unit is flush-mounted with no power, open the unit
by using the following procedure:
Using needle nosed pliers, grab one of the inside
columns at the bottom vent of the door (careful not to
scratch or damage the plastic/decoration) and pull door
open. A 90 degree angled screwdriver and/or angled hex
key may also be used by inserting into the middle of the
bottom door vent to catch the bottom of the plastic door
frame and carefully pull open (see below).
use needle nose
pliers to grab plastic
vent column.
use 90 degree angled screw
driver or an angled hex key
and insert through vent
opening to pull open.