Modular EM70/40 CPE Instalación, Uso, Mantenimiento página 21

Turn the knob to position " 1". Use position "3" to
top up water used during cooking. Water fills from
tap " E " located under the draining board.
Fill the well until the water is level with or above
the minimum level (bottom mark) indicated on the
rear wall of the well.
To halt filling, turn the knob to position "0" or "2".
Emptying
- Turn the handle " H " of the drain valve clockwise.
The drain is completely open when the handle is in
the vertical position.
BURNER IGNITION AND EXTINCTION
The gas valve control knob has the following
positions:
OFF
PILOT IGNITION
MAX. FLAME
PILOT IGNITION
- Press and turn knob to "pilot on".
- Press the knob fully down to activate the electronic
ignition and light the pilot burner.
- Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
- The pilot " ame can be seen through the peep hole
on the control panel.
MAIN BURNER IGNITION
- Press and turn the knob from position "pilot on" to
position "max. flame".
TURNING OFF
To switch the main burner off, turn the knob to
position "pilot on".
To switch off the pilot flame, press and turn the
knob to position "Off".
SWITCHING ON AND OFF
The energy regulator control knob has the
following positions:
OFF
MINIMUM POWER - HOLDING
INTERMEDIATE POWER - COOKING
MAXIMUM POWER
Switching on
Turn the energy regulator knob to any position
between "MIN" and "MAX".
The yellow indicator light switches on.
Turning off
Turn the energy regulator knob to position "Off".
The yellow indicator light switches off.
COOKING
- Fill the well.
- Turn the knob to position "2".
- Light the burners.
- Adjust the heating accoding to your cooking
requirements.
When the chosen cooking position is other than
"MAX", heating is intermittent. It switches on and
off automatically. The boiling intensity of the water
may vary visibly, but this has no effect on cooking.
When the heating switches off, the yellow
indicator light switches off too.
21