Modular EM70/40 CPE Instalación, Uso, Mantenimiento página 25

AFTER REPLACING A GAS SYSTEM
COMPONENT,
LEAKS AT CONNECTION POINTS.
DISCONNECT
ELECTRIC
BEFORE
OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS PASTA COOKER
REPLACING THE GAS VALVE, THE BURNES, THE
PILOT BURNER, THE THERMOCOUPLE, THE
ELECTRIC IGNITION, AND THE IGNITER.
- Remove the front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE ENERGY REGULATOR, THE KNOB
AND THE INDICATOR LIGHT.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PRESSURE SWITCH.
- Remove the front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC PASTA COOKER
Replacing the heating element
- Remove the front panel.
- Empty the well completely.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE ENERGY REGULATOR, THE KNOB
AND THE INDICATOR LIGHT.
- Remove the control panel.
CHECK FOR GAS
THE APPLIANCE
SUPPLY, IF PRESENT,
CARRYING OUT ANY
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PRESSURE SWITCH.
- Remove the front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
20. CLEANING THE INTERIOR
Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.
21. MAIN COMPONENTS
GAS PASTA COOKER
- Gas valve
- Main burner
- pilot burner
- Thermocouple
- Igniter
- Electric ignition
- Solenoid fill valve
- Energy regulator
- Control knob
- Indicator light
- Pressure switch
ELECTRIC PASTA COOKER
- Heating element
- Energy regulator
- Control knob
- Indicator light
- Pressure switch
25